Sherwood RD-6513 - Manual (Page 19)

ENGLISH
20
• While playing digital signals from Dolby Digital or DTS program source or listening in Dolby Pro Logic II Music mode, you
can adjust their parameters for optimum surround effect.
• Then "DRC : ~ " (or "PANO : ~ ") is displayed for several seconds.
• If the parameter mode disappears, press this button again.
When adjusting the sound parameters
1.
Press the SOUND PARAMETER button.
2.
Press the CURSOR UP(▲)/DOWN(▼) buttons to select the desired parameter.
When selecting the "DRC(Dynamic Range Compression:
Night mode)"
This function compresses the dynamic range of previously specified
parts of Dolby Digital or DTS sound track (with extremely high volume)
to minimize the difference in volume between the specified and non-
specified parts. This makes it easy to hear all of the sound track when
watching movies at night at low levels. The night mode can be set to
OFF or ON (default value : OFF).
Note : In some Dolby Digital or DTS softwares, the night mode may
not be valid.
When selecting the "PANO (Panorama)" mode
This mode extends the front stereo image to include the surround
speakers for an exciting "wraparound" effect with side wall imaging.
Select "OFF" or "ON"(default value: OFF).
When selecting the "C. WIDTH (Center width)" control
This adjusts the center image so it may be heard only from the center
speaker, only from the left/right speakers as a phantom image, or from
all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7(default value : 3).
When selecting the "DIMEN (Dimension)" control
This gradually adjusts the soundfield either towards the front or
towards the rear. The control can be set in 7 steps from -3 to +3
(default value : 0).
3.
Press the CURSOR LEFT(◀)/ RIGHT(▶) buttons to adjust the selected parameter as desired.
4.
Repeat the above steps 2 and 3 to adjust other parameters.
• Each time these buttons are pressed, the parameter mode
changes as follows:
→ "DRC" ↔ "PANO" ↔ "C.WIDTH" ↔ "DIMEN" ←
(Dynamic Range Compression) (Panorama mode) (Center width control) (Dimension control)
• "DRC" can be selected only while playing digital signals from
Dolby Digital or DTS source.
• "PANO", "C.WIDTH" and "DIMEN" can be selected only while
listening in Dolby Pro Logic II Music mode.
RD-6513(A) 2008.8.21 12:19 PM 페이지 20