Samsung SNC-B2331(P) - Manual (Page 33)

English _33
●
NETWORK CONNECTION AND SETUP
Click [OK].
Manual network setup will be completed.
When the manual setup including <IP> is completed, the camera will restart.
If the IP router has more than one camera connected
Configure the IP related settings and the Port related settings distinctly with each other.
Category Camera #1 Camera #2
IP related settings
IP Address
Subnet Mask
Gateway 192.168.1.200
255.255.255.0
192.168.1.1 192.168.1.201
255.255.255.0
192.168.1.1
Port related settings
HTTP Port
Device Port
TCP Port
UDP Port
Upload Port
Multicast Port 80
60001
60002
60003
60004
60005 10000
10001
10002
10003
10004
10005
If the <HTTP Port> is set other than 80, you must provide the <PORT> number in the address
bar of the Internet browser before you can access the camera.
ex) http://IP address : HTTP Port
http://192.168.1.201:10000
Auto Network Setup
Run <IP Installer.exe> to display the camera search list.
At the initial startup, both [Auto Set] and [Manual Set] will be grayed out.
For cameras found with the IPv6 setting, these buttons will be grayed out as the cameras do not
support this function.
Select a camera in the search list.
Find the MAC (Ethernet) address labeled
on the rear of the camera.
Both the [Auto Set] and [Manual Set]
buttons will be activated.
Click [Auto Set].
The AUTO SET dialog appears.
The <IP Address>, <Subnet Mask>,
and <Gateway> will be set automatically.
6.
7.
M

M

1.
2.