Samsung WM-202 - Manual (Page 10)

9
Connecting your radio to your computer network
1. Place your radio on a fl at surface and plug the cable from the mains
adaptor into the DC input socket located on the rear of your radio
(marked 'DC in') ensuring that the plug is pushed fully into the
socket.
2. If you wish to use a wired network connection, plug the Ethernet cable
into the RJ-45 socket at the back of the radio.
3. Plug the mains adaptor into a wall socket and switch on the socket.
IMPORTANT: The mains adaptor is used as the means of connecting
the radio to the mains supply. The mains socket used for the radio
must remain accessible during normal use. In order to disconnect the
radio from the mains completely, the mains adaptor should be removed
from the mains socket outlet completely.
4. When you apply power, the display on the radio will light up and say:
'ROBERTS' and 'STARTING' with a progress indicator. The fi rst time that
you use your radio (or after a Factory Reset) after a few seconds the
display will show a default date and time of 00/00/0000 and 00:00.
5. Press the On/Off button to take your radio out of stand-by. You should
see the main mode menu. Use the rotary Tuning/Select control to
point to "Internet Radio" and then select this function by pressing the
control.
If no network connection is yet confi gured, the radio will enter the
Network Settings Wizard and will display 'Scanning...'. After a short
while the display will show a list of the available WiFi networks. If you
are intending to use the WiFi connection, go to step 6.
To use the Ethernet connection to your router with automatic
confi guration, rotate the Tuning/Select control to point to the '[Wired]'
menu item. Press the control and the radio will attempt to connect.
Aux In
5