Sony BKMW-E3000 - Manual (Page 14)

14
Preparations
The M572: TEMP FILE CREATE setting page
appears.
4
Rotate the MULTI CONTROL knob to change the
setting.
enable: You can create files even after the capacity of
the memory label is exceeded. Files to be created
after the capacity of the memory label is exceeded
are temporary files.
disable (default setting): File creation is disabled
after the capacity of the memory label is exceeded.
5
Press the F5 (SET) button.
The message “Save Complete” appears.
Applying Changes to Basic Network
Settings
After changing basic network settings, you can use M58:
M50-M52 RENEW to apply the changes without
restarting the e-VTR. Proceed as follows.
1
Do steps 1 to 3 of “Basic Network Settings” (see page
9) to display the M5: NETWORK page of the
maintenance menu.
2
Rotate the MULTI CONTROL knob to bring the
cursor (*) to M58: M50-M52 RENEW and press the
F5 (SET) button.
The M58: M50-M52 RENEW page appears.
3
Rotate the MULTI CONTROL knob to set the setting
to ON.
4
Press the F5 (SET) button.
The message “Complete” appears.
OTHERS CONFIG
M570: REC WITHOUT TELE-F
M571: REC WITH TELE-F
M572: TEMP FILE CREATE
OTHERS CONFIG
M572: TEMP FILE CREATE
enable
Push SET button
M5 : NETWORK
M50 : IP ADDRESS
M51 : SUBNET MASK
M52 : DEFAULT GATEWAY
M55 : TAPE LEADER CONFIG
M56 : IP CONFIG
M57 : OTHERS CONFIG
M58 : M50-M52 RENEW
M59 : RESET ALL USER
M5 : NETWORK
M58 : M50-M52 RENEW
ON
Push SET Button
M5 : NETWORK
M58 : M50-M52 RENEW
ON
Complete