Southbend Swivel Mast Bandsaw sb1018 - Manual (Page 20)

-18-
For Machines Mfg. Since 8/09 Model SB1018 P R E P A R A T I O N
Power Connection
Electrocution or fire
may occur if machine is
ungrounded, incorrectly
connected to power, or
connected to an undersized
circuit. Use a qualified
electrician to ensure a safe
power connection.
Once your machine is set up and assembled as
previously described in this manual, it is ready to
be connected to the power source.
• If you plan to use the machine at 110V,
simply plug it into a receptacle on a 110V
circuit that meets the requirements listed on
Page 10.
• If you plan to use the machine at 220V, you
will have to convert the machine for 220V.
Refer to Electrical, beginning on Page 41.
16. Remove the shipping strap hex bolt and
strap with a 12mm wrench, as shown in
Figure 21. Re-install the fasteners. Save
this strap in case you need to transport or
ship the bandsaw in the future.
Figure 21. Removing shipping strap.
17. If you choose to use the deflector, position it
as shown in Figure 22 (the deflector directs
swarf from the cut and small workpieces into
the chip tray when the cut is complete).
Figure 22. Chip tray installed.
Deflector