Superior SDVST-N-B - Manual (Page 21)

21
MAINTENANCE TASK ACCOMPLISHING PERSON PROCEDURE
Inspect/Clean Burner, Logs
and Controls Qualified Service Technician Inspect valve and ensure it is properly operating. Check piping
for leaks. Vacuum the control compartment, fireplace logs and
burner area.
Check Flame Patterns and Flame
Height Qualified Service Technician Refer to Figures 5 and 9 on Pages 12 and 13 and verify the
flame pattern and height displayed by the appliance conforms
to the picture. Flames must not impinge on the logs. Ensure
flames are steady (not lifting or floating).
Inspect/Clean Pilot and Burner Qualified Service Technician Refer to Figure 11 on Page 14. Remove any surface build-up
on pilot and burner assembly. Wipe the pilot nozzles, igniter/
flame rod and hood. Ensure the pilot flame engulfs the flame
sensor as shown.
Check Vent System Qualified Service Technician Inspect the vent system at the top and at the base (within the
firebox) for signs of blockage or obstruction. Look for any signs
of dislocation or deterioration of the vent components. Note:
Excessive condensation can cause corrosion of caps, pipe &
fittings (excessive condensation can be caused by long lateral
runs, too many elbows and/or exterior portions of the system
being exposed to cold weather). Also inspect wall straps or
plumbers's tape to ensure it is secure and in place.
Appliance Checkout Qualified Service Technician Perform the appropriate appliance checkout procedure detailed
in this manual.
Replacing Glowing Embers Homeowner/Qualified Service
Technician Remove old ember materials (rockwool) and vacuum the ember
placement area. Place new embers as described on Page 12.
Periodically (After the Burning Season)
MAINTENANCE TASK ACCOMPLISHING PERSON PROCEDURE
Clean Firebox Interior Homeowner Carefully remove logs, embers (rockwool) and volcanic stone.
Vacuum out interior of the firebox. Clean firebox walls and log
grate. Replace logs, embers and volcanic stone as detailed in
this manual.
Check Flame Patterns and Flame
Height Homeowner Refer to Figures 5 and 9 on Pages 12 and 13 and verify the
flame pattern and height displayed by the appliance conforms
to the picture. Flames must not impinge on the logs.
Check Vent System Homeowner Inspect the vent system at the top and at the base (within the
firebox) for signs of blockage or obstruction. Look for any signs
of dislocation of the vent components.
Clean Front Glass Enclosure Panel Homeowner Clean as necessary following the directions provided in this
manual. DO NOT TOUCH OR ATTEMPT TO CLEAN GLASS
WHILE HOT.
Annually (Before the onset of the Burning Season)
MAINTENANCE SCHEDULE