Shoprider ISO9001 - Manual (Page 23)

~22~
GMP
ISO9001
ISO14001
ISO13485
CERTIFIED
1. Grasp the charging port cover and remove it from the charging port.
2. Plug AC power cord with female connector into the charging port shown as Fig.19.
3. Plug AC power cord with male connector into 110-volt wall outlet.
NOTE! The voltage suitable for the charger is different from districts. Please
assure to use the correct AC power cord for charging.
4. When charging is complete, grasp the charging port cover and position it in the
charging port.
5. The On / Off Charger Indicator will illuminate steady red indicating that the
charger is ON.
6. If the On / Off Charger Indicator is “blinking” red, this is abnormal. Unplug AC
power cord from the on-board battery charger and wall outlet. Contact your
provider as soon as possible.
7. When the On / Off Charger Indicator is off, the charger is off.
8. When the Charging State Indicator is “blinking” green, the batteries are charging.
9. When the Charging State Indicator is steady green, the batteries are fully
charged (or as fully charged as their condition will be allowed). At this point, the
charger automatically stops charging.
10. If the charger is on and the Charging State Indicator is off, the charger is
disconnected. Check that all connections are secure. If Charging State
Indicator is still off, unplug AC power cord from the on-board battery charger
and wall outlet. Contact your provider as soon as possible.
BATTERIES & BATTERY CHARGING
Charging Port with
Red Cover
On / Off Charger Indicator (Red LED)
& Charging State Indicator (Green LED)
Fig. 19