Smart Technologies SMART Hub PE260 - Manual (Page 14)

8 Configuring the SMART Hub PE260 99-00898-20 REV B0
6. Press Apply.
7. Close the NVIDIA Control Panel window and Default Monitor and NVIDIA GeForce
FX 5200 Properties dialog box.
Configuring the SMART Interactive Products
After configuring the projectors and displays, configure the SMART interactive products.
1. In the SMART Configuration Tools dialog box, press SMART Control Panel.
The SMART control panel appears.
2. Press SMART Board Settings.
The SMART Board Settings dialog box appears.
3. Ensure all interactive products connected to your SMART Hub appear in the
Select a SMART product list.
If an interactive product doesn’t appear in the Select a SMART product list and its status
light is red, disconnect and then reconnect the USB cable from your SMART Hub to the
interactive product. If the interactive product doesn’t appear in the list and its status light
remains red, contact SMART Technical Support for assistance.
4. In the Select a SMART product list, select the first interactive product.
5. Configure the interactive product using the dialog box’s controls.
For information on these controls, press Help.
6. Press Orient, and then orient the interactive product.
NOTE: If the orientation screen doesn’t appear on the correct display, press SPACEBAR
on the keyboard or the two buttons on the pen tray to move the screen.
7. Repeat steps 4 to 6 for each of the remaining interactive products.
8. Close the SMART Board Settings dialog box.
To configure the SMART Interactive Products