Smart Technologies SMART Hub PE260 - Manual (Page 17)

99-00898-20 REV B0 Configuring the SMART Hub PE260 11
5. If you want to change the period of inactivity before the projector or display enters standby
mode, press Automatic Standby, and then enter the appropriate information.
6. Repeat steps 2 to 5 for each of the remaining projectors or displays.
7. Close the display controller dialog box.
NOTE: During this procedure, a Windows Security Alert dialog box may appear. Press
Unblock to close this dialog box.
Control Action
seconds Type the number of seconds of inactivity before the projector or
display enters standby mode.
Activate standby
when the computer
shuts down Select this check box to start standby mode when your
SMART Hub shuts down.