Smart Technologies SMART Hub PE260 - Manual (Page 15)

99-00898-20 REV B0 Configuring the SMART Hub PE260 9
Configuring the Display Controller
The display controller allows you to centrally control projectors and displays connected to your
SMART Hub. With the display controller, you can:
• Specify a period of inactivity before each projector or display enters standby mode.
NOTE: The default period is five minutes.
• If your SMART interactive product includes a control module, turn on all projectors or
displays by pressing the Power button on the control module.
NOTE: Pressing the Power button on the control module turns on the projectors and
displays connected to your SMART Hub. It doesn’t turn on your SMART Hub itself.
To use the display controller, connect your SMART Hub to the projectors or displays with the
RS-232 connectors as instructed in the SMART Hub PE260 Textless Installation Guide
(
document 127261 ).
1. In the SMART Configuration Tools dialog box, press Projector Controller.
The display controller dialog box appears.
2. Press the icon labeled 1.
NOTE: This icon represents the first projector or display connected to your SMART Hub.
3. Select the Enable Control for this Display check box.
To configure the display controller
Power Button