Sim2 Multimedia HT 250 - Manual (Page 15)

HT 200/250
17
ENGLISH
Button : to switch-off to stand-
by.
Arrow button: to browse the On
Screen Display menu and to adjust.
Push Arrow Up or Arrow Down to
switch on from stand-by.
Menu button: to activate the On
Screen Display menu.
-Focus-Esc button: to de-
activate the On Screen Display
and to give access to the lens
zoom/focus adjustment functions.
Auto button: to enable auto-
configuration.
Press this button to automatically
optimise the displayed image.
Change the batteries in the remote control if experiencing
difficulty in sending commands to the projector.
If the remote control is not to be used for a long period of
time remove the batteries. Replace all batteries at the
same time; do not replace one new battery with a used
battery. If the batteries have leaked, carefully wipe the
case clean and replace with new batteries.
The remote control sends commands to the projector via
infrared signals.
It is possible to control the projector by pointing the remote
control at the screen; the sensor at the front of the projector will
pick up the reflected infrared commands.
(Fig. 44) .
Fig. 44
Avoid placing obstructions between the remote control
and the infrared sensor at the front of the projector; this
will impair the remote control performance.
12 DESCRIPTION OF THE
KEYBOARD PAD
Eight push buttons, at the rear of the projector, will allow
complete operation without the use of the remote control
(Fig. 45) .
Fig. 45
Keyboard