Sim2 Multimedia HT 250 - Manual (Page 5)

HT 200/250
7
ENGLISH
Do not obstruct the cooling air inlets on the top cover, or
the air outlets underneath the projector
(Fig 11) .
ƽ
CAUTION: Do not switch on the projector if it
is standing on soft surfaces such as cushions,
pillows, blankets, mattresses and carpets: the
air cooling outlets underneath, could become
obstructed.
Fig. 12
Take care not to shake the projector whilst carrying it by
the handle
(Fig 15) .
Fig. 15
Always position the projector on a stable, suitable surface,
away from direct heat sources.
Do not touch the surface of the projection lens.
Do not rest the projector on the side panels or on the rear
panel when in operation
(Fig. 16) .
OK! OK!
Fig. 16
Take care to position cables safely, especially in dark
places, in order to avoid a trip hazard
(Fig. 17) .
Fig. 17
CAUTION: Intense Light Source! Do not stare
directly into the projection lens as possible eye
damage could result. Be especially careful that
children do not stare directly into the beam (Fig. 13).
Do not open the projector’s cover; no user serviceable parts
are inside. Refer servicing to qualified service personnel.
Opening the projector’s cover will invalidate warranty
(Fig .14) .
Fig. 14
ƽ
Do not switch-on the projector if it is standing
on surfaces sensitive to heat, as this may result
in damage caused by the hot air outlets
underneath. Should this be unavoidable take
extra precaution of protecting the surfaces with
a layer of heat resistant material (Fig. 12).
Fig. 11
Fig. 13
ƽ
CAUTION: For installations using a ceiling or
wall-mounted bracket, carefully follow the
installation and safety instructions provided
with the bracket’s literature.
Please remove batteries from the remote control if not in
use for a long period of time.