Sun Microsystems X4150 - Manual (Page 21)

Chapter 2 Installing the Sun Fire X4150 Server Into a Rack with Slide-Rails 11
Caution – Always load equipment into a rack from the bottom up so that it will not
become top-heavy and tip over. Deploy your rack’s anti-tip bar to prevent the rack
from tipping during equipment installation.
Caution – Ensure that the temperature in the rack does not exceed the server’s
maximum ambient rated temperatures. Consider the total airflow requirements of all
equipment installed in the rack to ensure that the equipment is operated within its
specified temperature range.
Preparing the Slide Rails and Server for
Installation
Disassembling Slide-Rails
Do one of the following procedures before installation:
■ “Disassembling Bolt-On Slide-Rails” on page 12
■ “Disassembling Tool-less Slide-Rails” on page 12
Clearance depth behind front
mounting plane Distance to rear cabinet door is at least 800 mm (31.5
inches) with the cable management arm, or 700 mm
(27.5 inches), without the cable management arm.
Clearance width between front and
rear mounting planes Distance between structural supports and cable
troughs is at least 456 mm (18 inches).
Server Dimensions Length: (not including PSU handle): 28.0 inches
(711.2 mm)
Width: (not including ears): 16.75 inches (425.5 mm)
Height: 1U
TABLE 2-1 Rack Compatibility
Item Requirement