Sun Microsystems X4150 - Manual (Page 24)

14 Sun Fire X4150 Server Installation Guide • May 2009
Attaching the Slide-Rail Assemblies to the Rack
Do one of the following procedures to attach the slide-rail assemblies to the rack:
■ “Disassembling Bolt-On Slide-Rails” on page 12
■ “Disassembling Tool-less Slide-Rails” on page 12
Attaching Bolt-On Slide-Rail Assemblies
To attach bolt-on slide-rail assemblies to the rack:
1. Position a slide-rail assembly in your rack so that the brackets at each end of
the slide-rail assembly are on the outside of the front and rear rack posts. (See
FIGURE 2-3 .)
2. Attach the slide-rail assembly to the rack posts, but do not tighten the screws
completely.
Choose one of the following methods to attach the slide-rails. The method you
use varies, depending on the type of rack:
■ If your rack has threaded mounting holes in the rack posts, first determine
whether the threads are metric or standard, then insert the correct mounting
screws through the slide-rail brackets and into the threaded holes.
■ If your rack does not have threaded mounting holes, insert the mounting screws
through both the slide-rail brackets and rack posts, then secure them with the
caged nuts.