Sun Microsystems X4150 - Manual (Page 75)

65
C H A P T E R
6
If You Need Help
This chapter describes troubleshooting information and how to apply and remove
AC power to the Sun Fire X4150 server. Support contacts are also included.
This chapter includes the following topics:
■ “Powering On and Off the Server” on page 65
■ “Setup Troubleshooting” on page 67
■ “Contacting Support” on page 68
Powering On and Off the Server
Use the following procedures to power on and power off the Sun Fire X4150 server.
Power On the Main Power
To apply main power for all server components:
1. Verify that the power cord has been connected and that standby power is on.
In standby power mode, the Power/OK LED on the front panel flashes.
2. Use a stylus, pen, or other non-conducting pointed object, to press and release the
recessed Power button on the server front panel.
When the main power is applied to the server, the Power/OK LED next to the Power
button lights and remains lit, as shown in
FIGURE 6-1 .