Stamina Products Fusion 7100 - Manual (Page 11)

ASSEMBLY INSTRUCTIONS
11
STEP 9
NOTE: The RIGHT PEDAL(38) has R stamped on the end of the pedal shaft. The RIGHT PEDAL(38) has
right hand threads and is tightened by turning clockwise. The LEFT PEDAL(36) has L stamped on
the end of the pedal shaft. The LEFT PEDAL(36) has left hand threads and is tightened by turning
counterclockwise.
Thread the RIGHT PEDAL(38) into the RIGHT CRANK(33) as shown. Tighten the pedal securely. Select
the RIGHT PEDAL STRAP(39) which has R marked on the bottom side of the strap. Snap the two hole end
to the inside edge of the RIGHT PEDAL(38). Snap the other end to the outside edge of the RIGHT PEDAL(38)
with the R mark on the bottom of the RIGHT PEDAL STRAP(39). Select adjustment holes which allow your
foot to be easily removed from the pedals.
Use the same procedure to attach the LEFT PEDAL(36) to the LEFT CRANK(32) and snap the LEFT
PEDAL STRAP(37) to the LEFT PEDAL(36).
STEP 10
Slide the UPRIGHT SLEEVE(29) over the UPRIGHT(3). Connect the CONNECTION WIRE(25) to the
CONTROL WIRE(24). Insert the UPRIGHT(3) onto the FRONT FRAME(1) and secure with FLAT HEAD
BOLTS(M8x1.25x15mm)(70). Slide the UPRIGHT SLEEVE(29) down to cover the bolt heads.