Stamina Products Fusion 7100 - Manual (Page 18)

18
1.
2.
3.
4.
To store the Magnetic Fusion 7100 Bike, simply keep it in a clean dry place.
Adjust the SEAT FRAME(7) to the lowest position. The Magnetic Fusion 7100 Bike is approximately
53 1/4 inches long x 24 1/2 inches wide x 51 3/4 inches tall. These dimensions will vary. Please measure
your Magnetic Fusion 7100 Bike if exact dimensions are needed.
To move the Magnetic Fusion 7100 Bike, lift the REAR STABILIZER(6) and the bike will roll on the
WHEEL(54) on the FRONT STABILIZER(2).
To avoid damage to the electronics, remove the batteries before storing the Magnetic Fusion 7100 Bike
for one year or more.
The safety and integrity designed into the Magnetic Fusion 7100 Bike can only be maintained when the
Magnetic Fusion 7100 Bike is regularly examined for damage and wear. Special attention should be given
to the following:
Use the UP and DOWN buttons on the COMPUTER(26) to select a program and verify that the Magnetic
System provides different tensions. The Magnetic System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise. The right pedal has right
hand threads that are tightened by turning clockwise.
Verify that the WARNING LABEL(95) is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement WARNING LABEL(95) if it is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the Magnetic Fusion 7100 Bike removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the Magnetic Fusion
7100 Bike.
Keep your Magnetic Fusion 7100 Bike clean by wiping it off with an absorbent cloth after use. 1.
2.
3.
4.
5.
6.
7.
STORAGE
MAINTENANCE