Sony Ericsson CDP-XE570 - Manual (Page 13)

13 13
CDP-XE570
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed
in each block.)
For schematic diagrams.
Note:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and 1 / 4 W or less unless otherwise
specified.
• f : internal component.
• C : panel designation.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : STOP
(
) : PLAY
• Voltages are taken with a VOM (Input impedance 10 M Ω ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
J : CD
c : digital out
For printed wiring boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• x : parts mounted on the conductor side.
• a : Through hole.
• b : Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B)
pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
• Indication of transistor
C
These are omitted
E B
Q
C
These are omitted
E B
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
6-2. SCHEMATIC DIAGRAM LOADING MOTOR SECTION
11
(21)
S272
LOAD
IN
S271
LOAD
OUT
CN151
1
5
M151
LOADING
MOTOR
M
LOADING BOARD
1 - 6 4 5 - 7 2 1 -
TO MAIN BOARD
(Page 16)
6-3. PRINTED WIRING BOARD LOADING MOTOR SECTION • See page 12 for Circuit Board Location.
1.3 Vp-p
5.2 Vp-p
13.4 ms
4.5 Vp-p
40 ns
5.9 Vp-p
59 ns
approx.
200 mVp-p
2.7 V
7.5 µ s
1 IC101 ta (RFAC)
(CD Play Mode)
3 IC101 el (FE)
(CD Play Mode)
1.4 Vp-p
approx.
400 mVp-p
4 IC101 ra (TE)
(CD Play Mode)
8 IC501 el (EXTAL)
5 IC101 wh (MDP)
(CD Play Mode)
6 IC101 w; (SCOR)
(CD Play Mode)
7 IC101 yj (XTAO)
(CD Play Mode)
2 IC101 rd (RFD)
(CD Play Mode)
• WAVEFORMS
– BD Board –
– DISPLAY Board –