Samsung Q46 - Manual (Page 32)

31
General
European standards dictate maximum radiated trans-
mit power of 100 mW effective isotropic radiated power
(EIRP) and the frequency range 2400 – 2483.5 MHz.
Belgium
The product may be used outdoors, but for outdoor trans-
missions over a distance of 300m or more, a license from
the BIPT is required.
This restriction should be indicated in the manual as fol-
lows:
Dans le cas d’une utilisation privée, à l’extérieur d’un
bâtiment, au-dessus d’un espace public, aucun enregis-
trement n’est nécessaire pour une distance de moins de
300m. Pour une distance supérieure à 300m un enregis-
trement auprès de l’IBPT est requise. Pour une utilisation
publique à l’extérieur de bâtiments, une licence de l’IBPT
est requise. Pour les enregistrements et licences, veuillez
contacter l’IBPT.
France
For Metropolitan departments:
2.400 - 2.4835 GHz for indoor use.
2.400 - 2.454 GHz (channels 1 to 7) for outdoor use.
For Guadeloupe, Martinique, St Pierre et Miquelon, Mayo-
tte:
2.400 - 2.4835 GHz for indoor and outdoor use.
For Reunion, Guyane:
2.400 - 2.4835 GHz for indoor use.
2.420 - 2.4835 GHz for outdoor use (channels 5 to 13)
European Telecommunication Information
(for products fitted with EU-approved
modems)
Marking by the symbol indicates compliance of this
equipment to the Radio and Telecom Terminal Equipment
Directive 1999/5/EC. Such marking is indicative that
this equipment meets or exceeds the following technical
standards:
CTR 21 - Attachment requirements for pan-European
approval for connection to the analogue Public Switched
Telephone Networks (PSTNs) of TE (excluding TE
supporting voice telephony services) in which network
addressing, if provided, is by means of Dual Tone Multi-
Frequency (DTMF) signaling.
Caution
Although this equipment can use either loop
disconnect (pulse) or DTMF (tone) signaling, only
the performance of the DTMF signaling is subject to
regulatory requirements for correct operation.
It is therefore strongly recommended that the
equipment is set to use DTMF signaling for access
to public or private emergency services. DTMF
signaling also provides faster call setup.
This equipment has been approved to Council Decision
98/482/EEC - “CTR 21” for Pan-European single terminal
connection to the Public Switched Telephone Network
(PSTN).
However, due to differences between the individual
PSTNs provided in different countries, the approval
does not, of itself, give an unconditional assurance of
successful operation on every PSTN termination point. In
the event of problems, you should contact manufacturer
Technical Support.