Sony MAV-555 - Manual (Page 12)

12 4000CL-MAV, 250 Clip Fast Access System, for Sony MAV-555, with PBIO option
15. VIEW CONTENTS OF CUE POINT
a. Use
[NEXT CUE] or [LAST CUE] to access Cue Point.
Contents loaded at this Cue Point (CLIP ID) will be displayed.
OR
b.
Use numeric keypad to enter Cue Point number.
Press [ENTER].
Contents are displayed.
16. TRANSFERRING CUELIST
a. TRANSMIT CUE LIST FUNCTION
The TRANSMIT CUELIST function allows you to transmit your list of Cue Points to a
PC, using the provided utility software on the PC, or to another ST300. Transfer to a PC
requires OpSuite 3.0 software, which runs on a Windows-based computer. Contact DNF
Controls for more information.
1) TO TRANSMIT CUE POINTS TO THE ST300
a)
Connect the VTR4 connector on the rear of the ST300 to the VTR4
connector of the receiving ST300, using an RS422 9-pin cable with TX
and RX lines crossed.
(A “turnaround” cable)
b) Press
[MENU] and scroll the wheel to “Transmit CUE List?
YES=Enter, Exit=ESC.”
c) Press
[ENTER] to start transmitting. The Display shows “Waiting to
transmit.”
d)
When the Receiver is ready, transfer starts automatically.
The Display now shows “Transmitting cuelist.”
e)
After the transfer is over, the display shows “Transfer is over” for one
second, then shows “Waiting to transmit” again.
f)
Connect another ST300 to transmit the list again.
OR
Press [ESC] twice to exit.
2) TO TRANSMIT CUE POINTS TO THE PC
a)
Connect the VTR4 connector on the back of the ST300 to one of the
COM ports on the PC using a RS422 to RS232 adapter.
b)
Repeat steps b-f of the TO TRANSMIT CUE POINTS TO THE ST300
section.