Stanton S-450 - Manual (Page 8)

Set-up
1.Checking the Contents
Check that the carton contains the following items:
1. Tabletop unit
2. Operating instructions
3. One RCA cable.
4. One AC power cord.
2. Installing the Unit
1. Place your unit on a flat leveled surface.
2. Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high
humidity.
3. Try to place the unit as far as possible from TVs and tuners, as the unit may cause undesirable interference.
CAUTION:
Ÿ The player will work normally when the unit is within 15 degrees of the vertical plane. If the unit is tilted excessively,
discs may not be loaded or unloaded properly.
Ÿ The unit panel's LCD’s are designed to be clearly visible within the angles shown in Figure 1. Place the unit panel so
that the visual angle is within this range.
3.Connections
1. Make sure the unit is NOT powered on.
2. Connect the RCA pin cord to the input on your mixer.
CAUTION:
• Be sure to use the supplied cables. Using other types of cable may result in unit damage.
• To avoid sever damage to the unit, be sure the power is OFF when connections to the unit.
10
45
Sight point
Figure 1