Sony KDS-R50XBR1 - Manual (Page 34)

Connecting the TV
34
KDS-R50XBR1/KDS-R60XBR1
2-637-151-11(1)
D:\WINNT\Profiles\fujii\Desktop\SX_EN_source
_onDT062305\01US04INS.fm masterpage:3 columns Right
Setting Up the Channel List
After you finish connecting the TV, you can run the Initial Setup to create a
list of available analog and digital channels. The Initial Setup screen appears
when you turn on the TV for the first time after hooking it up. If you choose
to set up the channels at a later time, select the Auto Program option in the
Channel setting to scan available channels (see below).
Using Initial Setup To run Initial Setup the first time you turn on your TV
1
Press to turn on the TV.
The Initial Setup screen appears.
2
Press V or v to highlight the on-
screen display language. Then press
. The message “First please
connect cable/antenna.” appears. This
may require 50+ minutes for
completion and “Start auto program
now?” appears.
3
Press V or v to highlight “Yes” then press .
Auto Program performed through Initial Setup will automatically create a
list of receivable channels from both VHF/UHF antenna and cable TV
channels if both sources are connected.
To run Auto Program again at a later time
❑
Use the Auto Program feature as described on page 90.
To add individual digital channels
❑
Use the Digital Channels feature as described on page 90.
✍
The Intitial Setup feature does not apply for installations that use a
cable box for all channel selection.
✍
Auto Program may take a while (20 to 50 minutes) to complete. A
progress bar is displayed while available channels are being
scanned. If you cancel the Auto Program before all receivable
channels are scanned, you may want to perform the task later
(see “To run Auto Program again at a later time” below).
✍
If you selected “No” during the Initial Setup, the Initial Setup
message will appear each time you turn on the TV as a reminder
until you complete the Auto Program.