Sega Zombie Revenge - Manual (Page 11)

8
SECURING IN PLACE (ADJUSTER ADJUSTMENT)
Move the machine to the installation position.
Cause all of the leg levelers to make contact
with the floor. By using a wrench, make
adjustments in the height of the leg adjusters to
ensure that the machine's position is level.
After making adjustments, fasten the leg
adjuster nut upward and secure the height of the
leg adjuster.
The height of the table can then be determined
by adjusting the leg height of the table. The
Table has a range of 30” to 40” in height
depending upon the preferences of the operator.
This machine has 2 each of casters and 4 each of adjusters (shown below). When the installation position is deter-
mined, cause the adjusters to come into contact with the floor directly, make adjustments in a manner so that the
casters will be raised approximately 5mm. from the floor and make sure that the machine position is level.
Be sure to have all the Adjusters make contact with the surface. Un-
less the Adjusters come into contact with the surface, the Cabinet
can move of itself, causing an accident.
2
3
2
1
4