Booting the system – Samsung SHR-3010 User Manual

Page 15

Advertising
background image

3-2

GB

3-1

DIGITAL VIDEO RECORDER

1

Booting the System

Power On

There is a power switch on the upper right hand side behind the system. Pull the power
switch up to boot the system. Then, the LED on front of the system is turned on, a blue
screen with the following message will appear and the system is booted.

When you turn the system on, a blue screen appears and starts searching HDD. The message
in the screen tells any HDD exists in the main body. The main body can contain 2 HDDs,
one is installed properly but the other is not yet installed.
If the second HDD is installed, the message, ‘HDD DETECTED =>2 OK’ will be displayed.

When booting is finished, the following Live screen will appear.

Recognizing incoming video signal

SHR-3010 system can automatically recognize whether the video signal connected at the input port
is NTSC or PAL signal upon booting the system.
When you turn the system on, it will recognize if the image signal is NTSC or PAL automatically to
set itself to the signal.
If the system power is turned on without connecting video signals to the input port, the
system remembers the last signal and the system is configured accordingly. For example, if the past
video signal connected to the input port was an NTSC signal, the system is configured to fit NTSC
signals and for PAL, the same process is applied to fit PAL signals. However, if suddenly a type of
video signal that is different from the video signal currently connected to the input port is connected,
the screen will malfunction. In short, this is a case where PAL signal is connected to a system
configured to satisfy NTSC signals or the other way around. In these cases, system power should be
turned off, the new signal connected and then the system turned back on in order to be configured to
recognize the new signal.
If you power on the system without attaching the hard disk drive, you will get an error message
indicating that no hard disk drive was found.

GB

HDD DETECTED => 1 OK

HDD DETECTED => 2 NOT EXIST

2001-09-15 17:14:55

HDD DETECTED => 1 NOT EXIST

HDD DETECTED => 2 NOT EXIST

1

Advertising