Samsung SHR-3010 - Manual (Page 7)

GB
1-6
GB
1-5
DIGITAL VIDEO RECORDER
Rear View
1
2
3
4
5
No Name Function
EXTERNAL I/O
PORT
FAN
AC IN
POWER
● ALARM IN: In the N.C. (Normally Closed) mode, the system
recognizes an alarm when a High (5V) signal is input for over
0.5 seconds. In the N.O. (Normally Open) mode, the system
recognizes an alarm when a Low (0V) signal is input for over
0.5 seconds. (Please refer to “
➁ ALARM DETECT TYPE”
on p. 3-18.)
● ALARM RESET: The alarm mode is cleared when a Low (0V)
signal is input for over 0.5 seconds.
● ALARM OUT: A High (5V) signal is output during alarm
recording.
● TRIGGER OUT: This signal is for switching the recording
output screen of the Multiplexer.
● REC IN: The system begins recording when a Low (0V) signal
is input for over 0.5 seconds.
● DISK END: If the DISK END MODE of the RECORD
MODE SETUP is set to STOP, a Low (0V) signal is output for
about 1 second when the HDD becomes full during recording.
(Please refer to “
➃ DISK END MODE” on p. 3-16.)
Fan
Connects power cable.
Power On/Off button.
8
9
10
11
1 2 3 4 7 9 5 10 8 11 6
No Name Function
RS232 PORT
RS485 PORT
VIDEO IN/OUT
AUDIO IN/OUT
LAN
MODE
SCSI
Serial Port for remote control.
Serial Port for remote control.
Composite image signal I/O terminal (BNC Style Connector).
Audio Signal Input/Output Jacks (RCA Jacks).
LAN Cable Connection Terminal.
It is the DIP switch to set System ID, Direct Communication,
Termination, etc.
● 1~5 : System ID.
● 6 : Not Use.
● 7 : Termination On/Off (Of all the directly connected
systems, it sets the last system as On).
● 8 : Not Use.
SCSI Connector for Data Backup
6
7