Scientific Atlanta 3270HD - Manual (Page 27)

27
You can find out which codes are pro-
grammed into your remote by using the
following procedure.
1. Press SELECT and a mode key (AUX,
VCR, TV, or CBL) at the same time
until the light blinks twice.
2. Using the keypad on the remote, press
9 9 0. The light blinks twice.
3. Press 1; then, count the light blinks.
The number of light blinks indicates the
first digit in the code. For example, four
blinks indicates the first digit in the
code is 4. If the light does not blink, the
digit is 0.
What If None Of These Codes Work?
If none of the codes listed for your device
work, you can search through the code
library for a valid code.
1. Turn on the device.
2. Press SELECT and a mode key (AUX,
VCR, TV, or CBL) at the same time
until the light blinks twice. For
example, to search for a TV code, press
SELECT and TV at the same time.
3. Using the keypad on the remote, press
9 9 1. The light blinks once.
4. Point the remote toward the device, and
press POWER.
5. Did the device turn off?
• If no, press S to go to the next code,
and then press POWER to try again.
• If yes, press SELECT to confirm the
code.
Note: Each code library contains the
following number of codes:
• TV: 51 codes
• VCR: 56 codes
• AUX: 57 codes
• CBL: 10 codes
What Code Did I Find?
4. Press 2; then, count the light blinks.
The number of blinks indicates the
second digit in the code.
5. Press 3; then, count the light blinks.
The number of blinks indicates the third
digit in the code.
6. Press 4; then, count the light blinks.
The number of blinks indicates the
fourth digit in the code.
7. Write down your codes on page 7 of
this guide.