Scientific Atlanta 3270HD - Manual (Page 36)

36
Yes you can. To reset all of the advanced
features to the default settings, except the
codes you have programmed (TV, VCR,
AUX, and CBL) and any mode keys that
you may have reassigned, follow these
steps.
How Do I Lock My Power Key To a Device?
By default, the POWER key on your
remote operates the appropriate device for
the current mode. You can choose to set up
this key to operate multiple devices each
time it is pressed, regardless of the current
mode.
To change your power control:
1. Press SELECT and CBL at the same
time until the light blinks twice.
2. Using the keypad on the remote, press
9 9 8.
3. Press one of the following keys to
choose the way the POWER key should
operate:
• Press TV to turn on the set-top and
then the TV.
• Press VCR to turn on the set-top,
followed by the TV and the VCR.
• Press AUX to turn on the set-top,
followed by the TV and the auxiliary
device.
• Press CBL to turn on the set-top,
followed by the TV, the VCR, and
the auxiliary device.
• Press POWER to control all devices
individually. This is the default
setting.
The light blinks twice to indicate that the
change was accepted.
If your remote is set to control power on
more than one device, the remote always
defaults to CBL mode after you turn the
devices on or off. Also, if you press
POWER within three seconds of pressing
any mode key (VCR, TV, AUX, or CBL),
the POWER key only affects the associated
device. For example, if you press the VCR
key and then press the POWER key within
three seconds, the remote control only
turns on the VCR, regardless of the power
control setting.
Note: Your cable service provider will send
nightly programming updates to your set-
top (such as program guide information).
You should leave your set-top on at all
times so that it can receive these updates.
Can I Put It All Back the Way I Got It?
1. Press SELECT and CBL at the same
time until the light blinks twice.
2. Using the keypad, press 9 8 0. The
light blinks four times.
That’s it! All of the advanced features have
been reset to their factory defaults.