Schutt Sports C2000 - Manual (Page 12)

C1000 & C2000 Assembly Instructions
12 www.schuttsports.com 800-426-9784
Base Assembly - C1000
Step 1: Push two brackets (1) down to
raise brake feet and lower wheels.
Step 2: Remove four countersunk
screws from lower padding. (Lower
padding has six sides.)
Step 3: Attach padding to underside of
brackets using screws.
NOTE: Operate brake feet and wheels
as follows:
• To lower brake feet and raise wheels,
push up on padding until red lever
latches.
• To raise brake feet and lower wheels,
release red lever; pull out on
padding, and rotate padding down
completely.
Step 4: Remove two top screws from
unit rear and open door (2).
CAUTION: Without ballast material,
unit is unstable and can tip easily.
To prevent serious injury, do not
proceed past next step until unit
compartment is filled with ballast
material.
CAUTION: Unit is not designed for
dunking in goal or hanging on goal.
To prevent serious injury, do not
overload unit with excessive ballast
to permit improper goal use.
Step 5: Place 250–300 lbs (115–135 kg)
of ballast material into compartment.
Arrange material so that it does not shift
when moving or using unit.
Step 6: Close door (2) and install two
screws.
1
2