SIGMA BENEFON TDP-52-SN3 - Manual (Page 32)

27.1.1999
3DP_52GB 6
Product: TDP-52-SN3 /
4.2.3 Using the BeneLoc program
In the main window of the BeneLoc, you will find submenus and buttons. Clicking the
buttons you can go to the submenus.
Change
For changing phone to another similar you do not need to do more than enter into
main menu. It means that this button is not needed. If you are going to change the
tested phone to one having different software in, clicking Change will start the reg-
istration protocol again.
Help
About BeneLoc submenu will tell you version of the BeneLoc Program and also the
state of memory.
About Cellular submenu will show you information of the phone. Type of phones
software, sales date, date of the software, serial number and present tuning values
of the phone. You can not change the tuning values from Help menu.
Dealer
From Dealer submenu you can make or check programming of the phone. You will
also find the SIS information from Dealer submenu.
Service
You can control the audio lines (for example, switch Rx audio and compander on/off)
in the Service main menu. It is also possible to control the phone to desired channel.
There is also possible to change the power of transmitter.
In the Ports submenu is you can see the status of different digital ports. There is
also possible to control some of the output ports.
You can read the status of the A/D converters from the A/D submenu. Select 8 differ-
ent topics to view. By clicking SCAN AD button The Beneloc will scan A/D the state
of converters continuously. Scanning can stopped by clicking STOP AD.
Memory submenu allows you to make Ram reset.
By clicking Initialize You can clear all LOCAL settings in service menu.
Home button will return you back to main menu.