SIGMA BENEFON TDP-52-SN3 - Manual (Page 17)

27.1.1999
6DP_52GB 2
Product: TDP-52-SN3 /
It is possible to program the sales date ONLY ONCE, which means that you
will not be able to change it again afterwards. If the sales date has not been
programmed, your phone will not enter the normal stand-by mode.
3.1.1.2 Radio Path Identification
1. Press , and the following text will appear in the display:
RADIO PATH ID [XXXXXXXXXX].
2. Choose CHANGE. Enter the radio path identification (ten digits), and
save the identification by choosing SAVE. Remember to check that the
radio path identification is correct.
3.1.1.3 Phone Code
1. Press , and the following text will appear in the display:
PHONE CODE [XXXX].
2. Choose CHANGE. Enter the phone code (four digits), and save the code
by choosing SAVE.
3.1.1.4 Closing Instructions
1. Having programmed the necessary information choose QUIT, and the
following text will appear in the display: ***BENEFON***.
2. Turn off your phone, and disconnect the localbox.
3. Turn the phone on once more, and make a test call.