Sony PAL NTSC 4.43 SLV-SE80UX - Manual (Page 15)

Getting Started
Getting Started
15
Step 5
Tuning your TV to the VCR
If you have connected the VCR to your TV using the EURO-AV cable,
skip this step.
RF CHANNEL
1
Press RF CHANNEL on the VCR lightly.
The factory-preset RF channel appears in the display window.
The VCR signal is output through this channel to the TV.
2
Turn on your TV and select a programme position for the VCR
picture.
This programme position will now be referred to as the video
channel.
3
Tune the TV to the same channel as that
shown in the display window so that
the picture on the right appears clearly
on the TV screen.
Refer to your TV manual for tuning
instructions.
If the picture does not appear clearly,
see “To obtain a clear picture from the
VCR” below.
RF CHANNEL
SONY VIDEO CASSETTE RECORDER
continued