Sony PAL NTSC 4.43 SLV-SE80UX - Manual (Page 8)

Getting Started 8
Step 2 : Setting up the remote commander (continued)
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
To make wide mode settings, see the footnotes below this table for the
applicable code numbers.
* 1 Press WIDE to switch the wide picture mode on or off.
* 2 Press WIDE, then press Á +/– to select the wide picture mode you want.
* 3 Press WIDE. The menu appears on the TV screen. Then, press >/./?// to
select the wide picture you want and press OK.
Notes
• If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control your TV with the remote commander.
• If you enter a new code number, the code number previously entered will be erased.
• When you replace the batteries of the remote commander, the code number may
change. Set the appropriate code number every time you replace the batteries.
Code number
01* 1 , 02
68
52
10*
1 , 11* 1
24
33
45
09, 70
66
15, 16, 69*
3
Code number
17* 1 , 49
06* 1 , 07* 1 , 08* 1
12, 13
22, 23
25
29
36
43*
2
38
Manufacturer
Panasonic
Philips
Saba
Samsung
Sanyo
Sharp
Telefunken
Thomson
Toshiba
Manufacturer
Sony
Akai
Ferguson
Grundig
Hitachi
JVC
Loewe
Mivar
NEC
Nokia