Schneider Optics Web Embedded Server - Manual (Page 43)

The MSTR Instruction
840 USE 115 00 Version 1.0 33
3.2.6 Clear Local Statistics MSTR Operation
The Clear Local Statistics operation (type 4 in the displayed register of the top
node) clears statistics relative to the local node where the MSTR has been
programmed.
Control Block
Utilization The registers in the MSTR control block (the top node) contain the Clear Local
Statistics information as described in the following table:
3.2.7 Get Remote Statistics MSTR Operation
The Get Remote Statistics operation (type 7 in the displayed register of the top
node) obtains information relative to remote nodes on the network. This operation
may require multiple scans to complete and does not require a master data
transaction path. (See page page 40 for a listing of the TCP/IP Ethernet network
statistics).
The remote comm processor always returns its complete statistics table when a
request is made, even if the request is for less than the full table. The MSTR
instruction then copies only the amount of words you have requested to the
designated 4x registers.
Note: TCP/IP Ethernet routing must be accomplished via standard third-party
Ethernet IP router products.
Register Function Content
Displayed Operation Type 4
First implied Error status Displays a hex value indicating an MSTR error,
when relevant.
Second implied Not applicable
Third implied Not applicable
Fourth implied Low byte Quantum backplane slot address of the NOE
module.
Fifth ... Eighth
implied Not applicable