Schneider Optics Web Embedded Server - Manual (Page 29)

Installing and Configuring the Module
840 USE 115 00 Version 1.0 19
Turn the locking ring to align an arrow with the key. Then align the key with the
keyway. As a result, the locking tab, groove and lock should also be aligned.
Slide the clasp up to the locking ring. Gripping the cable with the clasp, plug the
cable into the lower (receive) cable connector. If it does not connect easily, realign
the key with the arrow and try again.
Turn the cable to the right, so that the tab locks securely. You may leave the fiber
cable clasp on the cable for future use, but slide it off the boot of the cable to allow
the module door to close.
Repeat this process with the remaining strand of cable and the upper (transmit)
cable connector.
When connecting the cable to the hub, make sure that the strands are crossed. The
transmit port of one device should be linked to the receive port of the other.
Figure 13 Attaching the Cable
Locking Tab
Locking Ring
Fiber Cable Clasp
Keyway
Connector
Key