Sanyo DSR-3016 - Manual (Page 70)

RECORDING SETTING
5
Repeat the above procedure to set the alarm duration for
other cameras.
6
Press the EXIT/OSD button.
The display returns to the normal screen.
Resetting an alarm
☞ When images from the camera where the alarm
was detected are appearing in a single-screen
display
1
Press the camera select button for the camera that is being
shown in the single-screen display for approximately
3 seconds.
The alarm will then be canceled.
☞ When images from the camera where the alarm
was detected are displayed in a multiple-screen
1
Press the camera select button for the camera that is showing
the alarm.
The alarm images will appear in a single-screen display.
2
Press the camera select button again for approximately
3 seconds.
The alarm will then be canceled.
Note: Alarms can also be reset by using the ALARM RESET button
on the rear panel of the digital video recorder.
<ALARM DURATION SET>
IN IN IN IN
01:10S 02:5S 03:5S 04:5S
05:5S 06:5S 07:5S 08:5S
09:5S 10:5S 11:5S 12:5S
13:5S 14:5S 15:5S 16:5S
EXIT/OSD
4
4
4
English 69