Schumacher XI41DU - Manual (Page 12)

• 9 •
PROBLEM REASON SOLUTiON
Inverter does not turn on. Poor contact at terminals
Fuse is blown.
Inverter may be defective.
Check for poor connection
to battery or power supply.
Make sure connection points
are clean. Rock clamps
back and forth for a better
connection.
A blown fuse is usually
caused by reverse polarity
or a short circuit within the
inverter.
To replace, contact a qualified
service technician who will
diagnose the inverter and
replace the fuse(s) with the
appropriate replacement(s).
See warranty and call
Customer Service 1-800-621-
5485 (Hours 7:00 am to 5:00
pm CST).
SPECiFiCATiONS 10.
Model: Xi41dU
Maximum Continuous Output ---------------------------------------------------------- 410 Watts
Surge Capacity (0.1 second) ----------------------------------------------------------- 820 Watts
No Load Current Draw ------------------------------------------------------------------------- <0.5A
Output Wave Form ----------------------------------------------------------- Modified Sine Wave
Input Voltage Range ----------------------------------------------------------- 10.5V – 15.5V DC
Output Voltage Range -------------------------------------------------------------- 120V ± 5% AC
Low Battery Alarm ------------------------------------------------------- Audible, 11V ± 0.3V DC
Low Voltage Shut Off ------------------------------------------------------------ 10.5V ± 0.3V DC
Over Voltage Shutdown --------------------------------------------------------- 15.5V ± 0.5V DC
Optimum Efficiency ------------------------------------------------------------------------------- 85%
AC Receptacle ------------------------------------------------------------ Two, NEMA 5 - 15 USA
USB Port -------------------------------------------------------------------- One, USB 5V 0.5 Amp
Dimensions --------------------------------------------------------------------- 5” L x 4” W x 2.2” H
Weight --------------------------------------------------------------------------- approximately 2 lbs.