Sega WORLD SERIES '99 - Manual (Page 19)

16
REMOVING AND ATTACHING THE BAT MECHA
If you need to remove the BAT MECHA as in the case of a failure, open control panel base and remove the BAT
MECHA through the following procedure.
To reinstall the BAT MECHA, reverse the removing procedure, being certain that the BAT MECHA is faced in the
correct direction.
To prevent electrical shock, be sure to turn off power to the cabinet when remov-
ing or attaching the BAT MECHA
1.) Remove the wiring connector (AMP 3P, white) located near the volume.
2.) Remove the tamperproof screw clamping the bat center axis on the front side of the control panel.
3.) Remove the four flange nuts clamping the BAT MECHA body on the back side of control panel.