Sega WORLD SERIES '99 - Manual (Page 8)

5
2. ASSEMBLING AND INSTALLATION
Assembling should be performed as per the cabinet’s service manual.
Since this is a complex machine, erroneous assembling may cause
damage to the machine, or malfunctioning to occur.
When assembling, be sure to perform work by plural persons.
Depending on the assembly work, there are some cases in which
performing the work by a single person can cause personal injury or
parts damage.
KIT INSTALLATION INSTRUCTIONS
1.) Install VGA Output to Jamma Interface.
2.) Install USB connector to Naomi Filter Board Port.
3.) You can use one of the extra grounds (shown in the picture on
the following page) to go out to switched inputs. (The 5V and 12V
can be used for whatever you like-coin meter, etc.)
MONITOR INFORMATION
You can use a
Standard Resolution-15,750K x 60 (#1 ON & #2-4 OFF)
or
High Resolution-31,000K x 10 (#1-4 OFF)
DIP SWITCH SELECTABLE
(Switch #1 on NAOMI FILTER BOARD)