Roughing-in, Raccordement – Sterling Plumbing Bath and Wall Surrounds 6103 Series User Manual

Page 8

Advertising
background image

Roughing-In

IMPORTANT!

All dimensions are nominal. The stud opening tolerance is +1/8

″ (3

mm)/-0. Carefully measure your fixture before determining enclosure size. Some

shimming between the stud frame and the fixture may be required. If a firewall is

required, rough-in dimensions will have to increase according to the thickness of the

firewall material. Stud opening dimensions must be measured toward the exposed

side of the wall material. Dimensions given in the rough-in information are crucial for

proper installation. Construct the framing and plumbing accurately.
The bath and optional wall surrounds can be installed directly to the framing studs and

wallboard or other water-resistant material. When installing over wallboard or other

water-resistant material, increase the framing dimensions to accommodate the material

thickness.
Position the bath for drainage clearance through the floor joists or slab, and for

convenient plumbing installation.
Position studs as shown for installing attachment clips and plumbing fixtures.
Install an access panel at the drain end of the bath. The access panel is not shown.
If installing this bath with a shower door, refer to the shower door manufacturer’s

instructions for any special framing considerations.

Raccordement

IMPORTANT!

Toutes les dimensions sont nominales. L’espacement du montant est

de +1/8

″ (3 mm) /-0. Mesurer soigneusement votre appareil avant d’en déterminer la

taille de son logement. Un calage entre le cadre du montant et l’appareil sanitaire

pourrait être nécessaire. Si un pare-feu est requis, les dimensions de raccordement

devront augmenter en fonction de l’épaisseur du matériau du pare-feu. Les

30" (76.2 cm)

60" (152.4 cm) Min
60-1/8" (152.7 cm) Max

60" (152.4 cm)

7-3/4"
(19.7 cm)

3-1/2" (8.9 cm)

4"
(10.2 cm)

7-3/4"
(19.7 cm)

31-1/4"
(79.4 cm)

31-1/4"
(79.4 cm)

22-1/4"
(56.5 cm)

8" (20.3 cm)

14-1/4"
(36.2 cm)

14-1/4"
(36.2 cm)

73-1/2"
(186.7 cm)

2" (5.1 cm) D.
Drain/Drain/Desagüe

6"
(15.2 cm)

8"
(20.3 cm)

14"
(35.6 cm)

Support Clip or Roofing Nail Location (5 total)
Emplacement pour le clip de support ou clou pour toiture (5 total)
Lugar para el clip de sujeción o clavo de techar (5 en total)

Drain Cutout
Découpe du drain
Abertura del desagüe

3"
(7.6 cm)

1064907-2-A

8

Sterling

Advertising