Sub-Zero UC-15I - Manual (Page 13)

13
S U B - Z E R O I C E M A C H I N E I N S T A L L A T I O N
I N S TA L L AT I O N
3) Remove the upper plastic trim piece (right
hand configured) from the door by removing
the two screws that secure it to the door.
Then replace it with left hand trim piece.
Refer to the illustration on page 12.
4) Transfer the hinges to the left side of the
door and re-attach. The upper hinge will
need to become the lower hinge and the
lower hinge will now need to become the
upper. Refer to the illustration below.
5) Remove the top ice machine cover by
removing the two screws along the back of
the unit. Refer to the illustration below.
6) Remove four screws from the front top rail.
Refer to the illustration below.
7) Pivot top rail end for end to expose the two
left hand top hinge screw holes and reinstall.
8) Remove 2 screws from bottom trim plate
and slide to cover right hand hinge
mounting screw holes and expose left
hand hinge mounting screw holes. Refer to
illustration below.
9) Install the door using the left-hand door
mounting holes. Install shim removed in
step 1 between the hinge and cabinet.
10) Check the operation of the door by opening.
Transfer hinges and reattach Remove top cover Remove front top rail Slide bottom trim plate
Step 4 Step 5
Step 6
Step 8