SCI Scandicrafts A2840/R - Manual (Page 18)

17
NOTE: To purify a stinky spot on the carpet, cover the air purifier and the spot with a light sheet creating the
tent effect as you did with your bedding. Make sure you don’t block the airflow through the air purifier.
Mold Blast the Basement
This step will amaze you as your nasty, mold and mildew-smelling basement becomes transformed into
a sweet smelling pleasant place to spend time. Now, you may have to run a dehumidifier if the
basement environment is really damp. Mold and mildew love dampness.
A. Place your air purifier in the center of the basement about 5 to 6 feet above the floor or as high as possible.
B. Turn the air purifier on. Set the purify setting to its highest level (G-7). Select the ozone option
for the area model. Set the fan to high.
C. Place an additional fan in the room if necessary to circulate the Activated Oxygen to every corner of
the basement if the basement has poor airflow.
D. Allow the “setup” to run for 6 to 8 hours for mild/moderate problems. Allow it to operate from 2 to 4
days if you have a serious problem in your basement. Remember, according to experts, if you can
smell the mold or mildew, you could be at risk! So, let's remove and/or significantly reduce deadly mold!
NOTE: For severely infected or damp areas, consider a second air purifier. ALSO REMEMBER:
When you set up for initial purifying for purging purposes and when oxidizing mold you will normally
smell a detergent like smell resembling chlorine until there is a reduction in the amount of mold.
Hammer Remodeling Fumes
This step can help reduce and eliminate those hazardous toxic fumes and dust created in your home
during and after you paint, lay carpet, install cabinetry or after almost any remodeling job! This
procedure can be amazing and is worth recommending to friends who are also remodeling or building.
A. Place your air purifier in the center of the room about 5 to 6 feet above the floor.
B. Turn the air purifier on. Set the purify setting to its highest level (G-7). Select the ozone option
for the area model. Set the fan to medium.
C. Place an additional fan in the room to circulate the Activated Oxygen to every corner of the room if
the area has poor airflow.
D. Allow this “setup” to run for 2 to 24 hours, or longer, depending on the smell. Let your nose be the judge.
NOTE: You may initially get a "bleach" smell, that's good! It tells you the O
3 is transforming the toxins,
chemicals and bacteria into pure oxygen, H 2 O, O 2 and carbon dioxide.
Flush Your Bathroom
This step can help reduce that nasty mold and mildew; it will also help keep those gross, infectious,
microscopic bacteria and creatures from taking over your bathroom!
A. Place your air purifier in the center of the bathroom about 5 to 6 feet above the floor.
B. Turn the air purifier on. Set the purify setting to its highest level (G-7). Select the ozone option
for the area model. Set the fan to medium.
C. Allow the “setup” to run for 2 to 4 hours.
D. This procedure should be repeated at least once per month to help maintain a safe and healthy
bathroom. Also keep in mind that when you have the purifier on, it is for purging purposes and when
oxidizing mold you will normally smell a detergent-like smell resembling chlorine until there is a
reduction in the amount of mold. However, the air purifier does not produce Chlorine, it only
produces activated oxygen. This is the same natural process the sun and thunderstorms produce to
clean up the outdoor air pollution.
Spring Clean the Closet
Oxidize chemicals from dry cleaning or smelly clothes in general
This step can help you reduce or eliminate that stale old smell from all of your closets and storage units.
A. Place your air purifier in the center of the closet or storage space up as high as you can get it. If
what you're purifying is a small item like a chest or trunk, close the lid within 1 inch of fully closed.
You must allow some fresh air in for your air purifier to work best.
B. Turn the air purifier on. Set the purify setting to its highest level (G-7). Select the ozone option
for the area model. Set the fan to high.
C. Make sure the back (G-7) or sides (area model) of your air purifier are clear so you maintain
good airflow through the machine.
D. Watch the cord so that you don’t pinch it when closing the door.
E. Allow this “setup” to run for 1 to 2 hours depending on how fully you pack your closet or the size of
the storage area. It is OK to run it all day.
NOTE: For stinky, smelly shoes or a smoke drenched jacket, place the item in front of your air purifier
for an extra hour or so.
I-4506 BR7580R-1 6/25/07 7:57 AM Page 5