Spectrum Brands SPECTRUM PLUS SP-550 - Manual (Page 34)

Programming Voice Mail
(Administrator Programmable Only)
To program the SpectrumPLUS TM one touch “MESSAGE WAITING” speed dial key, follow
these programming instructions.
Programming Voice Mail Dialing
1. Press and hold the “STORE” key to activate
Administrator mode.
2. Press the “STORE” key multiple times until
“VOICE MAIL NO.” is displayed on the LCD
screen.
3. Enter the voice mail number. The area code is
not required if AREA CODE is programmed
into memory.
4. Press the “STORE” key to store the voice mail
number into the VOICE MAIL memory key.
5. Enter the “PIN NUMBER”, up to 8 digits. The
PIN characters will not be displayed.
6. Enter the “SECONDS OF WAIT?”, up to 99
seconds.
7. To exit the program mode, press “DISC” or
continue to the end of programming by pressing
the “STORE” key multiple times until the dis-
play reads “All Setup OK”.
Test the program
After programming voice mail, test the program by
placing a voice mail into the voice mail messaging
system. Then, press the key located on the base unit
(when in OFF HOOK position) and dial the pre-
programmed numbering sequence. The “SECONDS
OF WAIT” may need to be increased if the voice
mail was not retrieved.
33
VOICE MAIL NO.
12/01
PM
12:00
555-1212
PIN NUMBER
12/01
PM
12:00
- - - - - - - -
SECOND OF WAIT?
12/01
PM
12:00
05