Woodstock SHOP FOX W1706 - Manual (Page 15)

-13-
Model W1706 (Mfg. Since 3/13)
SE
TU
P
12. Place the fence assembly onto the front rail and
position it to the left of the table insert, then secure
it in place by pressing down on the lock lever (see
Figure.12).
Figure.12. Fence secured in place.
Lock Lever
DO. NOT. operate. this. machine. without. an. adequate.
dust.collection.system..This.machine.creates.substan-
tial.amounts.of.wood.dust.while.operating..Failure.to.
use.a.dust.collection.system.can.result.in.short.and.
long-term.respiratory.illness.
Recommended.CFM.at.Dust.Port:................. 400.CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the
dust port, you must take into account many variables,
including the CFM rating of the dust collector, the length
of hose between the dust collector and the machine, the
amount of branches or Y's, and the amount of other open
lines throughout the system. Explaining this calculation
is beyond the scope of this manual. If you are unsure of
your system, consult an expert or purchase a good dust
collection "how-to" book.
Dust.Collection
To.connect.a.dust.collection.hose,.do.these.steps:
1. Slide a 4" dust hose over the dust port and secure it
in place with a hose clamp, as shown in Figure.13.
2. Tug on the hose to make sure it is secure.
Note:.A tight fit is necessary for proper dust
collection.
Figure.13. Dust collection hose connected
to the dust port.