SUPER MICRO Computer X7DVL-3 - Manual (Page 23)

Chapter 2: Installation
2-3
Socket Key
(Socket Notch)
South Center Edge
North Center Edge
Load Lever
CPU in the CPU socket
Plastic cap
is released
from the
load plate
if CPU
properly
installed.
3. Use your thumb and your index
fi nger to hold the CPU at the North
Center Edge and the South Center
Edge of the CPU.
4. Align CPU Pin1 (the CPU corner
marked with a triangle) against the
socket corner that is marked with a
triangle cutout.
5. Align the CPU key that is the
semi-circle cutout below a gold dot
against the socket key, the notch on
the same side of the triangle cutout
on the socket.
6. Once aligned, carefully lower the
CPU straight down to the socket.
(**Do not drop the CPU on the socket.
Do not move the CPU horizontally or
vertically. Do not rub the CPU against
the surface or against any pins of the
socket to avoid damage to the CPU
or the socket.)
7. With the CPU installed in the
socket, inspect the four corners of
the CPU to make sure that the CPU
is properly installed. Then, close the
load plate.
8. Use your thumb to gently push the
load lever down to lock it.
9. If the CPU is properly installed into
the socket, the plastic cap will be
automatically released from the load
plate when the clip is pushed in the
clip lock. Remove the plastic cap from
the motherboard.
(Warning: Please save the
plastic PnP cap. The motherboard
must be shipped with the PnP cap
properly installed to protect the CPU
socket pins. Shipment without the
PnP cap properly installed will cause
damage to the socket pins.)
!
CPU Key (semi-
circle cutout)
below the circle.
CPU Pin1
Corner with a
triangle cutout
gold dot