Silvercrest KH6500-06/08-V1 - Manual (Page 11)

- 9 -
Installing the rechargeable battery
1. Plug the rechargeable battery connections into
the connection opening on the rear panel of the
device.
2. Slide the rechargeable battery slightly sideways
in the direction indicated on the battery until it
audibly locks into place.
Charging the battery with the power supply
unit
1. Plug the device plug of the power supply unit or
the 12V vehicle adapter into the socket on the
side of the device.
2. Plug the power plug of the power supply unit
into the power socket or the 12V vehicle adap-
ter into the Vehicles cigarette lighter socket.
• While the battery is charging the operation light
on the side of the battery is illuminated red.
• When the battery is fully charged the operation
light on the side of the battery turns green.
Removing the rechargeable battery
1. Slide the locking tab on the side of the recharge-
able battery in the direction of the arrow and
hold in this position.
2. Pull the rechargeable battery in the opposite
direction to the arrow and then pull backwards.
6.3 Connection to another device
The DVD player can be connected to televisions
which operate with the PAL or NTSC standards. In
this way you can transmit the display onto the tele-
vision screen. If you want to use the DVD player on
a television operating under the NTSC standard
you may have to select the NTSC television stan-
dard in the video settings of the DVD players so cal-
led "OSD Menu" (see chapter 8.4. "Special set-
tings: TV TYPE")
Video connection to the television
1. Switch off the DVD player and the television.
2. Insert the yellow jack plug of the video cinch
cable in the VIDEO IN/OUT socket of the DVD player.
IB_KH6500_AR23388_LB6 01.08.2008 11:47 Uhr Seite 9