Silvercrest KH6500-06/08-V1 - Manual (Page 13)

- 11 -
Playback of an external devices audio and
video signals with the DVD player
You can playback images and sound from an
external device via the DVD player.
1. For sound transmissions insert the red jack plug
of the audio cinch cable into the AUDIO IN/OUT
COAX socket of the DVD player.
2. Insert the white and red cinch plugs of the audio
cinch cable into the corresponding audio output
of the external device.
3. Insert the yellow jack plug of the video cinch
cable in the VIDEO IN/OUT socket of the DVD player.
4. Connect the cinch socket of the video cinch
cable with the corresponding video output
of the external device.
5. Switch on the DVD player and the external device.
6. In order to playback the external devices audio
and video signals press the AV button on the re-
mote control.
7. In order to switch back to the DVD's display,
press the button DVD/USB/CARD .
Note:
Depending on the data carrier the display can
remain black for a few seconds until the DVD play-
ers image is again displayed.
Note:
The sound of an external device connected to the
DVD players audio input will also playback if the
device is set to an operating mode other than AV.
6.4 Headphone connection
Attention!
Only use the supplied earphones, type HX206-001.
You can connect headphones with a 3.5 mm stereo
jack plug to the DVD player. The headphone con-
nection is located on the side of the device. When
you connect the headphones the loudspeaker will
be switched off and you will only hear sound from
the headphones.
• Insert the jack plug of the headphones into the
headphone connection.
Important!
Listening to music over long periods with
full volume on headphones can lead to
hearing damage
IB_KH6500_AR23388_LB6 01.08.2008 11:47 Uhr Seite 11