Siemens Electrical Lean Switch - Manual (Page 67)

Diagnostics over Industrial Ethernet
Industrial Ethernet
A5E00152007-03
67
6.3.9 Trap Configuration
Clicking the Trap Config menu opens the window shown in Figure 6-15.
Figure 6-15 Trap Configuration Window
If an alarm occurs, the ELS can send traps (alarm messages) to up to two different
(network management) stations at the same time. In this menu, you enter the
addresses of the stations to which the traps will be sent. The corresponding events
must also be activated in the "Event Configuration Menu".
● Trap Address x
Enter the IP addresses of the stations to which traps will be sent (range per
field: 0 to 255).
● Get Current Values/Set New Values
If you click the "Get Current Values" button, you obtain the values currently
stored on the ELS. To save the entries made in this window, click the "Set New
Values" button.