Sony CMT-J3MD - Manual (Page 12)

12
2
Press CD A and place a CD on the disc
tray.
A
HS
HS
h
H S
`/1
ENTER/YES
NAME EDIT/
CHARACTER
1
Insert a recordable MD.
A
A
HS HS
h H
S
Recording a CD on an MD or a
tape (continued)
6
Press ENTER/START again.
Recording starts. When the recording is
completed, the CD player and the MD deck
stop automatically.
To stop recording
Press s.
Tips
• If you use a partially recorded MD, recording starts
after the recorded tracks.
• The track numbers of the CD are recorded on to the
MD automatically.
• Depending on the disc, CD TEXT information may
also be recorded (except when you record on an
MD and a tape at the same time). If “CD-TEXT”
flashes during recording, press NAME EDIT/
CHARACTER on the remote, and then press
ENTER/YES on the remote to record the title of the
current track. (If “CD-TEXT” is lit, it is
automatically recorded.)
Note
If “Cannot SYNC!” appears, a disc is not loaded or
you cannot record on that MD (see page 72).
If the MD becomes full during
recording
The CD player and the MD deck stop
automatically.
Before pulling out the mains lead
MD recording is completed when the MD Table
of Contents (TOC) is updated. The TOC is
updated when you eject the MD or press ?/1 to
turn off the system. Do not pull out the mains lead
before updating the TOC (while “TOC” is lit) or
while updating the TOC (while “TOC” or
“STANDBY” is flashing) to ensure a complete
recording.
With the arrow
pointing
toward the
deck
With the label
side up, and
the shutter on
the righthand
side
3
Press CD A to close the disc tray.
4
Press SYNCHRO REC repeatedly until
“CD-MD SYNC ?” appears.
5
Press ENTER/START.
The MD deck stands by for recording and the
CD player pauses for play.
With the label
side up. When
you play a CD
single (8 cm
CD), place it on
the inner circle
of the tray.