Sony CMT-J3MD - Manual (Page 14)

14
With the arrow
pointing
toward the
deck
?/1 (power)
Tips
• When you want to record on the bottom side, press
TAPE h in step 6.
• When you record on both sides, be sure to start
from the top side. If you start from the bottom side,
recording stops at the end of the bottom side.
• If you select both sides recording and the tape
reaches the end of the top side part-way through a
track, the entire track is recorded again from the
beginning of the bottom side.
• When you want to reduce the hiss noise in low-
level, high-frequency signals, press DOLBY NR
after step 5 so “DOLBY NR” appears in the
display.
Note
If “Cannot SYNC!” appears, a disc or a tape is not
loaded or you cannot record on that tape (see
page 73).
Recording on an MD and a
tape at the same time
1
Perform step 1 of “Recording on an
MD” (see page 11) and steps 1 to 3 of
“Recording on a tape” (see page 13).
2
Press SYNCHRO REC repeatedly until
“DUAL SYNC ?” appears.
3
Perform steps 5 to 7 of “Recording on a
tape”.
Tips
• Even if the MD or the tape ends part-way through
the recording, the other continues recording.
• If you select both sides recording and the tape
reaches the end of the top side part-way through a
track, the entire track is recorded again from the
beginning of the bottom side. In this case, the entire
track may also be recorded again on the MD.
Note
If “Cannot SYNC!” appears, a disc or a tape is not
loaded or you cannot record on that tape (see pages
72 and 73).
Playing an MD
To turn on the system, press ?/1 (power). You
can play an MD just like a CD.
HS
A
A
M m l L
h H
HS
`/1
2
VOLUME s
lm/ML
MD A
1
Insert an MD.
A
A
HS HS
h H
S
Recording a CD on an MD or a
tape (continued)
With the label
side up, and
the shutter on
the righthand
side
2
Press MD HS.
Play starts. The indicator on the MD HS
button lights green.
Track number Playing time