Sony MZ-N10 - Manual (Page 92)

92
NO SET • You tried to set Digital Pitch Control while the “AUDIO OUT”
parameter was set to “LINE OUT”.
, Use the jog dial to set the “AUDIO OUT” parameter to
“HeadPhone”.
• You tried to make the following settings while recording.
— Personal Disc Memory
— Melody Timer
— Digital Pitch Control
— Recording mode
— Recording level
— Selection of “
: REC” in menu
— Selection of “REC-Posi” during recording to a group.
NoOPERATE • You pressed + or – while programming a track using the
remote control.
• You tried to make the Auto Time Mark setting while recording
through digital connection.
• You tried to press X or T MARK during synchro-recording.
NO SIGNAL • The recorder could not detect digital input signals.
, Make sure that the source is connected firmly (page 23).
P/B ONLY • You tried to record or edit on a pre mastered MD (P/B stands for
“playback”).
, Insert a recordable MD.
PROTECTED • You tried to record or edit on a MD with the tab in the record-
protect position.
, Slide the tab back (page 79).
Push STOP • You tried to open the lid while the recorder was storing disc
information.
, Open the lid only after pressing x and “TOC Edit” has
disappeared from the display.
READ ERR • The recorder cannot read the disc information correctly.
, Reinsert the disc.
REC ERR • Recording was not correctly done.
, Place the recorder at a place with no vibrations and record
again.
• The disc is soiled with an oil film or finger prints, is scratched, or
is not a standard disc.
, Try recording again with another disc.
Rehearsal • You tried to operate a button and or a lever (other than the control)
on the remote control while the recorder is performing rehearsal
play during a track division operation.
Error message Meaning/Remedy